Remotely Control Icom Transceivers through an IP Network
• The RS-BA1 allows you to use the radio installed in another room using your home network or
even from a remote location over the Internet.
• Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio.Advanced Remote
Control Interface Tailored to Icom Transceivers
• Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled. Also, S-meter and SWR can
• Rx Voice recording function.
The RS-BA1 consists with two component software
applications; System configuration software and remote
control software. The system configuration software sets
up IP address, audio sampling rate and other settings. The
remote control software provides a user interface, similar to
the radio's front panel, and allows you to control the radio
from a remote location.
The IC-7600, IC-7200 or IC-9100 can be connected to a PC
with a USB cable and the input/output audio signal and
CI-V command is sent through the USB cable.
The IC-7800 or IC-7700 can be connected to a PC with a
RS-232C cable plus S/P DIF or ACC cable.
Quick Guide to RS-BA1 operation