PTC-IIIusb-BT with PACTOR III and Bluetooth
Bluetooth interface for wireless connection to Bluetooth enabled PC up to 10 meters away. The PTC-IIIusb-BT includes a USB interface with certified USB drivers for a wired connection to the modem if needed.
PACTOR I, II and III modes enabled, standard.
Built-in VHF/UHF Packet (is not multiport capable - see DR-7800 and PTC-IIpro)
GPS NMEA data input
Transceiver Frequency control for many (most) radio models
Same on air performance as all PTC modems in PACTOR I, II & III and Packet modes
The PTC-IIIusb-BT comes with: Installation Guide, USB cable, audio cable (connector at one
end, raw wires at the other end), power connector and CD-ROM.
Audio input impedance: 47 k
Audio input level: 10 mVp-p... 2Vp-p
Audio output impedance: 1 k
Audio output level: Max. 3 Vp-p (open circuit), adjustable in 1 mV steps
Audio processing: Digital signal processor DSP56303 clocked at 100 MHz 768 kByte additional DSP-RAM for data and program
Central processor: Motorola MC68360 QUICC 32 bit CMOS CPU clocked at 25 MHz
ROM: Max. 256 kByte, CMOS, FLASH-ROM for easy updates
RAM: Static: 2 MByte, CMOS
System monitoring: With an internal processor watchdog
Operating temperature: -10 to +50 C
Front panel: 8 LEDs split into various functional groups. ON / OFF Touch sensor switch
Rear panel: Power supply, DIN Socket for transceiver audio, DIN socket for transceiver remote control, GPS connector - 3 wire screw terminal, USB "B" connector
Power Supply: +10 to +20 V DC, 300 mA max.
Reverse polarity protected, Fuse selfresetting
Dimensions: Width 4.92" (125) x Height 1.69" (43) x Depth 5.43" (138) mm
Weight: 15.87 oz (450g)
Bluetooth interface: Class 2, 25mW max, 4dBm, ~10 meters range
Check for your interconnect cables here using the
Cable selection chart